NEOFLOOR are tough, hard wearing, chemical and abrasion resistant coatings that helps the surface to last long without compromising any of the properties of the concrete floor. Based on solvent less two component Epoxy System, NEOFLOOR provides monolithic, smooth, non-porous, hygienic coating that is easy to clean and maintain. It is available in wide range of colours and has sufficient strength to withstand industrial traffic with nylon / rubber wheels. It offers improved performance while maintaining ease of application. NEOFLOOR is designed for all concrete surface (old/new).Features
NEOFLOOR P is a 2 component epoxy primer that is applied on floor prior to coating NEOFLOOR S or NEOFLOOR SLT.
NEOFLOOR S is a three component abrasion resistant flooring screed laid by trowel.
Industrial Floors, Warehouse Floors, Automotive Showrooms, Bathrooms, Laboratories, Assembly & Production Areas, Commercial Buildings, Schools, Hospitals, Offices, Retail Facilities.
Ensure that surfaces are clean free from loose dust particles, moisture, oil, grease, any previous coatings etc. A sound, clean and dry concrete substrate is absolutely essential in ensuring maximum bonding. New concrete surface must be a minimum of 28 days old, free from curing compounds and sealers, free from moisture vapour release and have a moisture content of less than 5%. Application temperature below 40oC & relative humidity less than 85% is recommended.
NEOFLOOR is supplied in 3 different pre-weighed packs (Base, Hardener, Aggregates). Mix Base and Hardener thoroughly and then add the aggregates slowly upon continuous stirring. Mix for 3 mins and apply before pot life. It is ideal to mix small quantity. Note that improper mixing may affect the appearance and performance.
Post preparation of surface apply Primer Coat using NEO FLOOR P. This gives
better adhesion to intermediate coat and bonding to concrete surface. Follow it
up with Screed Coat with NEO FLOOR S. The Screed coating provides good abrasion,
impact resistance, high strength, heavy duty and good anti-skid base for
flooring. Finish the coating process with Top Coat using NEOFLOOR SLT. The top
coating offers excellent surface levelling and smooth attractive finish to the
NEOFLOOR coatings are applied with a notched trowel to the required thickness for getting desired properties. The liquid coating is poured and spread evenly with a spreader. Then spread using a spike roller to ensure complete de aeration of the coating. Wear spike shoes during application. Stop rolling before 20 mins of pouring the material. Freshly applied coating must be protected from usage for at least 18 hrs. Pot life & Curing time will increase upon decrease in ambient temperature and vice versa.
Store in an air tight container, in dry conditions between 10oC to 30oC
All tools and equipment can be cleaned with NEO Thinner ET-509 immediately after use.